1 road with a coupler relay module expan...

1 road with a coupler relay module expansion board low level triggered 5V/9V/12V/24V

Product description:
1 , the module complies with international safety standards, the control area and the load region isolation trench ;
2 , the module with opto isolation , touch found reliable, more stable ;
3 , using double-sided FR-4 circuit board design , high-end chip production process ;
4, using loose music authentic relay control ;
5, with the power supply and relay instructions , pull off, disconnect does not shine ;
6 , there are low-level signal input signal, the common terminal will start with regular conduction ;
7 , the relay can control the various devices and the load ;
8 , there is a normally open and one normally closed contact ;
9 , blue KF301 terminals to the control line is more convenient.
10 , module size : 53x18x18.5mm; Weight : 18g

Module interface :
Input section :
VCC: positive power supply ( by relay voltage supply )
GND: tied to power supply
IN: signal relay module trigger terminal ( low trigger active )

Output section :
Normally open (NO): normally open relay , the relay does not suck timely , with the common disconnect suction timely and common terminal connected ;
Common terminal (COM): the relay common terminal ;
Normally Closed (NC): normally closed relay , relay no suction timely , and the common terminal connected, disconnect suction timely and public side .

High and low meaning:
High level trigger signal triggers the end refers to the (IN) and the negative power supply voltage between a forward , usually with positive power supply terminal is connected with the trigger a trigger , when the trigger -terminal positive voltage or reach the trigger voltage , the relay is energized .
Refers to a low level trigger signal triggers the end of the negative power supply voltage between OV , or said trigger terminal voltage than the power supply positive voltage lower , low enough to trigger voltage, the relay , which is usually the the negative power supply terminal is connected with the trigger a trigger , the relay is energized .





Relay contact capacity: 250V 10A (AC) or 30V 30A (DC) (theoretical maximum load capacity)

Connect ac power 1500W recommended the following, then below 200W DC


1.5V LOW relay module with opto isolation




2.9V LOW relay module with opto isolation




3.12V LOW relay module with opto isolation





4.24V LOW relay module with opto isolation